E1 -failure of the printed circuit board of the indoor unit, the remote control is connected incorrectly or is faulty.
E2 - duplication of addresses of internal blocks
E3 - invalid outdoor unit address
E5 - defective control board of the outdoor unit
E6 - evaporator temperature sensor closed / disconnected
E7 indoor unit sensor short-circuited
E8 - evaporator overload or sensor defective
E9 - error of the drainage pump or float sensor
E10 - more than 16 indoor units are connected to the control panel
E11 - more than one unit is connected to the control panel when the address is busy
E12 - address setting error
E14 - incorrect master-slave connection settings (master-slave)
E16 - defective indoor unit fan
E28 - defective control panel sensor
E30 - error connecting outdoor / indoor units
E31 - duplication, incorrect address settings
E32 - wrong phase sequence or wire break
E33 - open compressor winding
E34 - open phase L3 winding 52C
E35 - high condenser temperature or temperature sensor defective
E36 - Inadmissible exhaust air temperature deviation
E37 - defective condenser temperature sensor
E38 - defective outdoor temperature sensor
E39 - faulty thermal sensor discharge pipe
E40 - 63N1 high pressure switch tripped
E49 - system has stopped, low pressure or insufficient refrigerant
E52 - 52C failure
E53 - defective suction pipe thermistor
E54 - low pressure sensor disconnected
E55 - defective compressor thermistor
E56 - The power transistor thermal sensor is defective or broken
E57 -Not enough refrigerant
E59 - the compressor does not start
E60 - compressor positioning error
E63 - emergency shutdown of the indoor unit
This list of fault codes is intended for Mitsubishi Heavy Air Conditioners models: